AT5040
microphone
$2,999
Gebrauchtmarkt: $2,340*
Technische Daten
1 von 9 Werten mit vermerkter Quelle- Connectors
- XLR 3-Pin Male·
- Has Built In ADC
- no·
- Self Noise d BA
- 5·
- Transducer Type
- Condenser Electret✓
- Sensitivity dBV
- -25·
- Output Impedance ohms
- 50·
- Phantom Power Required
- yes·
- Connection Architecture
- XLR-Only·
- Updated At
- 2026-08-05T23:27:57.543Z·
Kommentar des Toningenieurs
Tonal Profile
Four rectangular electret elements wired as one - the output is the sum, which is where the 5 dB floor and the -25 dBV/Pa come from. Cardioid only, no pad, no filter: it is a fixed-purpose vocal microphone at a price where most competitors sell switches.
Gain Staging Advice
-25 dBV/Pa is the loudest output in this batch by 5 dB, and 5 dB-A is the lowest floor. Thirty dB of gain on a close voice is plenty; the risk here is the interface input clipping, not preamp noise. Max SPL is only 142 dB and there is no pad.
Was im Datenblatt tatsächlich steht
Wörtlich von der Herstellerseite zitiert, mit dem Datum der Prüfung. Wir behaupten das Gedruckte, nicht die Absicht dahinter.
«固有雑音の等価音圧レベル 5dB S.P.L.»
The noise row names no weighting, and unlike on the AT4033a the signal-to-noise row does not either: «SN比(1kHz at 1Pa) 89dB以上». 94 minus 89 is 5, so the two rows agree with each other, but nothing on the sheet says whether either is A-weighted. On the same manufacturer's AT4033a page the S/N row reads «77dB（1kHz at 1Pa、A特性）».
geprüft am 6.8.2026* Geschätzt über das Abschreibungsmodell (~78% Restwert). · geprüft am 6.8.2026