OC818
microphone
$999
Gebrauchtmarkt: $780*
Technische Daten
1 von 9 Werten mit vermerkter Quelle- Connectors
- XLR 3-Pin Male, Mini-XLR 5-Pin (rear diaphragm output)·
- Has Built In ADC
- no·
- Self Noise d BA
- 9·
- Transducer Type
- Condenser True·
- Sensitivity dBV
- -37.7✓
- Output Impedance ohms
- 275·
- Phantom Power Required
- yes·
- Connection Architecture
- XLR-Only·
- Updated At
- 2026-08-05T23:27:57.590Z·
Kommentar des Toningenieurs
Tonal Profile
A dual-output multipattern: the main XLR carries the front diaphragm, a 5-pin mini-XLR carries the rear one, so the pattern can be chosen after the take in software. Everything else is a conventional 1-inch externally polarised condenser.
Gain Staging Advice
9 dB(A) at -37.7 dBV/Pa is a good floor for a quiet output. If you use the dual-output mode you need two preamps that match, because any gain difference between them becomes a pattern error, not a level error.
Was im Datenblatt tatsächlich steht
Wörtlich von der Herstellerseite zitiert, mit dem Datum der Prüfung. Wir behaupten das Gedruckte, nicht die Absicht dahinter.
«Sensitivity (all directions) 13 mV/Pa»
This is the well-labelled version of a trap that catches most multi-pattern sheets. Austrian Audio gives one sensitivity for cardioid, omni, figure-8, hypercardioid and every programmable position in between - but says so in the row label. Neumann's TLM 107 and Audio-Technica's AT2050 print a single figure without naming the condition; here the reader at least knows the number is meant to hold across patterns.
geprüft am 6.8.2026* Geschätzt über das Abschreibungsmodell (~78% Restwert). · geprüft am 6.8.2026