AudioChainsDB
Fosi Audio

TB10D

amplifier

$80

Gebrauchtmarkt: $60*

Datenblatt des Herstellers

Technische Daten

3 von 5 Werten mit vermerkter Quelle
Amp Type
Power Amp·
Channels
2·
Speaker Outputs
5-Way Binding Posts·
Power Output Per Channel
{"thdPercent":10,"continuousWatts":300,"loadImpedance_ohms":4}
Min Supported Impedance ohms
2

Kommentar des Toningenieurs

Headroom Notes

The stored rating is the one Fosi's own text attaches conditions to: 300 W per channel into 4 ohms at 10 % THD. Ten per cent is the clipping point, not a listening condition; the same sentence gives 150 W per channel into 8 ohms 'unclipped', which is the figure worth planning around. The specification table separately prints 'THD <= 0.3 %' with no power attached, so the two cannot be combined.

Thermal Behavior

'Terminating Impedance 2-8 ohms' - a published two-ohm floor, which almost nobody in this catalogue states. Believe it only together with the supply: the box ships a 32 V / 5 A brick, and Fosi says the 300 W figure needs 48 V / 10 A. At 32 V / 5 A the amplifier cannot draw more than 160 W from the wall no matter what the load is.

Was im Datenblatt tatsächlich steht

Wörtlich von der Herstellerseite zitiert, mit dem Datum der Prüfung. Wir behaupten das Gedruckte, nicht die Absicht dahinter.

Messbedingungen
«The device is operated in AD-mode, and can drive up to 2 x 300 W into 4-Ω load at 10% THD and 2 x 150 W unclipped into 8-Ω load. ... What you Get: TB10D amplifier x1, User Manual x1, 32V/5A Power Adapter x1 (Note: You need a more powerful power supply to get the MAX 300W x2 power output, such as 48V/10A.)»

Der Produkttitel nennt 300 W x2, die Tabelle wiederholt es - beide Bedingungen dafür stehen jedoch außerhalb der Tabelle. Erstens 10 % Klirr: der Punkt, an dem das Signal sichtbar begrenzt wird, etwa doppelt so viel Leistung wie die nutzbare. Zweitens ein Netzteil, das nicht beiliegt; Fosi schreibt es selbst in die Packliste. Mit dem mitgelieferten 32-V/5-A-Netzteil zieht der Verstärker höchstens 160 W aus der Steckdose - 600 W Ausgangsleistung sind also nicht bloß optimistisch, sondern unerreichbar, bis ein zweites Netzteil gekauft wird. Die 150 W pro Kanal an 8 Ohm 'unclipped' im selben Satz überstehen beide Bedingungen.

geprüft am 5.8.2026

* Geschätzt über das Abschreibungsmodell (~75% Restwert). · geprüft am 5.8.2026