AudioChainsDB
Klipsch

RP-500M II

speaker

$650

Gebrauchtmarkt: $470*

Datenblatt des Herstellers

Technische Daten

4 von 4 Werten mit vermerkter Quelle
System Type
Passive Bookshelf·
Input Terminals
Single aluminum binding posts
Nominal Impedance ohms
8
Sensitivity dB 2.83V 1m
92

Kommentar des Toningenieurs

Headroom Notes

92 dB at 2.83 V / 1 m is the highest sensitivity in this batch, and on an 8-ohm nominal it converts one-to-one to dB/W/m. The footnote is what to read carefully: the measurement is «half-space anechoic», which adds roughly 3 dB over a free-field figure, and the same footnote then calls the result «in-room sensitivity». A 10 W amplifier genuinely goes loud with these; it goes about 3 dB less loud than 92 dB would suggest when compared against a free-field number.

Amplification Warning

No minimum impedance anywhere on the spec sheet, and the nominal row does not give a nominal either — it reads «8 Ohms Compatible». For a horn-loaded two-way with a 1530 Hz crossover the impedance curve is usually benign, but that is inference, not documentation. Power handling is given as 75 W continuous / 300 W peak, which is the only load-related number the sheet actually commits to.

Was im Datenblatt tatsächlich steht

Wörtlich von der Herstellerseite zitiert, mit dem Datum der Prüfung. Wir behaupten das Gedruckte, nicht die Absicht dahinter.

Wie eine andere Größe benannt
«NOMINAL IMPEDANCE 8 Ohms Compatible»

Die Zeile heißt «NOMINAL IMPEDANCE», der Wert «8 Ohms Compatible» nennt aber die zulässigen Verstärkerausgänge, nicht die Last des Lautsprechers. Eine Minimalimpedanz fehlt im gesamten Datenblatt, sodass kein Wert die Frage nach der sicheren Last beantwortet. Wharfedale formuliert dieselbe Zeile genauso.

geprüft am 5.8.2026
Messbedingungen
«*SPL at 1M, half-space anechoic with 2.83V input, in-room sensitivity»

Die Fußnote zum 92-dB-Wert widerspricht sich in sechs Wörtern: «half-space anechoic» ist eine Laborbedingung — reflexionsarmer Raum mit bündig eingebautem Lautsprecher —, «in-room» das Gegenteil. Halbraum bringt gegenüber Freifeld rund 3 dB mehr; der Wert ist also weder mit Freifeldangaben vergleichbar noch eine Vorhersage für Ihren Raum.

geprüft am 5.8.2026

* Geschätzt über das Abschreibungsmodell (~72% Restwert). · geprüft am 5.8.2026