MODEL 40n
amplifier
$2,700
Gebrauchtmarkt: $1,945*
Technische Daten
3 von 6 Werten mit vermerkter QuelleKommentar des Toningenieurs
Headroom Notes
Only the 8 ohm rating is recorded, and that is deliberate. Marantz publishes 70 W x 2 into 8 ohms and 100 W x 2 into 4 ohms under one honest heading - 20 Hz to 20 kHz, both channels driven simultaneously - but the distortion line underneath is qualified '8 ohms load'. There is no published distortion figure for the 4 ohm rating, so attaching 0.02 % to it would be our invention rather than Marantz's statement.
Thermal Behavior
The connection page states 4 - 16 ohms outright: 'Use speakers with an impedance of 4 - 16 ohms.' It is on the speaker-connection page, not in the specification table, which is where most people look and do not find it.
Was im Datenblatt tatsächlich steht
Wörtlich von der Herstellerseite zitiert, mit dem Datum der Prüfung. Wir behaupten das Gedruckte, nicht die Absicht dahinter.
«RMS Power output (20 Hz – 20 kHz simultaneous drive of both channels) : 70 W x 2 (8 Ω/ohms load) 100 W x 2 (4 Ω/ohms load) / Total harmonic distortion (20 Hz – 20 kHz simultaneous drive of both channels, 8 Ω/ohms load) : 0.02 %»
Zwei Leistungsangaben, ein Klirrwert - und beim Klirrwert steht die Last in Klammern: 8 Ohm. Die 100 W an 4 Ohm sind damit eine Zahl, der im gesamten Dokument keine Klirrgrenze zugeordnet ist. Das ist keine Kleinigkeit: An 4 Ohm lässt sich fast jede Wattzahl angeben, wenn der zulässige Klirr offenbleibt. Wir speichern deshalb nur die 8-Ohm-Angabe und belassen den 4-Ohm-Wert in dieser Notiz, wo er zusammen mit dem Fehlenden lesbar ist.
geprüft am 5.8.2026* Geschätzt über das Abschreibungsmodell (~72% Restwert). · geprüft am 5.8.2026