AudioChainsDB
Q Acoustics

5010

speaker

$650

Gebrauchtmarkt: $470*

Datenblatt des Herstellers

Technische Daten

7 von 6 Werten mit vermerkter Quelle
System Type
Passive Bookshelf
Input Terminals
Binding posts
Min Impedance Dip ohms
3.3
Nominal Impedance ohms
6
Recommended Power watts
Max Continuous: 90 · Min Continuous: 15
Sensitivity dB 2.83V 1m
86.3

Kommentar des Toningenieurs

Headroom Notes

86.3 dB at 2.83 V on 6 ohms is about 85.1 dB/W/m. With 15–90 W recommended and a 56 Hz lower limit at −6 dB, this is a near-field or small-room speaker; the sensitivity leaves little margin for a large room even at the top of the power range.

Amplification Warning

A 110 mm two-way in five litres, 6 ohms nominal and 3.3 ohms minimum. That minimum is barely above the 3.0 ohms of the 5040 floorstander, which is unusual: a small bookshelf normally presents an easier load than a tower with two woofers in parallel. Size the amplifier for 4 ohms and ignore the 6 in the nominal row.

Was im Datenblatt tatsächlich steht

Wörtlich von der Herstellerseite zitiert, mit dem Datum der Prüfung. Wir behaupten das Gedruckte, nicht die Absicht dahinter.

Messbedingungen
«Sensitivity (2.83V @ 1kHz) 86.3 dB/w/m»

Drei Teile dieser einen Zeile widersprechen einander: Ansteuerung 2,83 V, Einheit dB/W/m, Abstand nur in der Einheit, in der Bedingung dagegen 1 kHz. Bei 6 Ω sind 2,83 V rund 1,33 W, also etwa 1,25 dB Unterschied. Wir folgen der Messbedingung.

geprüft am 5.8.2026

* Geschätzt über das Abschreibungsmodell (~72% Restwert). · geprüft am 5.8.2026