NT55
microphone
$389
Gebrauchtmarkt: $305*
Technische Daten
0 von 9 Werten mit vermerkter Quelle- Connectors
- XLR 3-Pin Male·
- Has Built In ADC
- no·
- Self Noise d BA
- 15·
- Transducer Type
- Condenser True·
- Sensitivity dBV
- -38·
- Output Impedance ohms
- 100·
- Phantom Power Required
- yes·
- Connection Architecture
- XLR-Only·
- Updated At
- 2026-08-05T23:27:57.624Z·
Kommentar des Toningenieurs
Tonal Profile
A modular half-inch pencil: JFET impedance converter, a switchable pad and low cut on the body, and capsules that unscrew. Sold singly and as a matched pair for overheads and ORTF.
Gain Staging Advice
-38 dBV/Pa is quiet and 15 dBA is mid-pack; on a quiet source this is a microphone that will expose a weak preamp before it exposes the room.
Was im Datenblatt tatsächlich steht
Wörtlich von der Herstellerseite zitiert, mit dem Datum der Prüfung. Wir behaupten das Gedruckte, nicht die Absicht dahinter.
«Polar Pattern Cardioid, Omnidirectional / Sensitivity -38.0dB re 1 Volt/Pascal (12.60mV @ 94 dB SPL) +/- 2 dB @ 1kHz»
The NT55 ships as a body with two interchangeable screw-on capsules - a cardioid and an omni - and the sheet gives one sensitivity and one 15 dBA noise figure for the pair, naming neither capsule. A pressure omni and a pressure-gradient cardioid of the same diameter do not normally have the same output. The reference is at least stated in full («re 1 Volt/Pascal»), which is more than most of this microphone's competitors do.
geprüft am 6.8.2026* Geschätzt über das Abschreibungsmodell (~78% Restwert). · geprüft am 6.8.2026