sE4400a
microphone
$699
Gebrauchtmarkt: $545*
Technische Daten
0 von 9 Werten mit vermerkter Quelle- Connectors
- XLR 3-Pin Male·
- Has Built In ADC
- no·
- Self Noise d BA
- 13·
- Transducer Type
- Condenser True·
- Sensitivity dBV
- -32·
- Output Impedance ohms
- 22·
- Phantom Power Required
- yes·
- Connection Architecture
- XLR-Only·
- Updated At
- 2026-08-05T23:27:57.630Z·
Kommentar des Toningenieurs
Tonal Profile
A four-pattern one-inch condenser with a hand-built gold-sputtered capsule and a very low 22-ohm output impedance - lower than anything else in this batch. Two pads and two low cuts.
Gain Staging Advice
-32 dBV/Pa is loud and 22 ohms drives long cable without complaint; 13 dB(A) is competent rather than remarkable. Note the site refuses plain automated requests - it needs a browser-like header set to answer at all.
Was im Datenblatt tatsächlich steht
Wörtlich von der Herstellerseite zitiert, mit dem Datum der Prüfung. Wir behaupten das Gedruckte, nicht die Absicht dahinter.
«Sensitivity 25 mV / Pa (-32 dBV) / Equivalent noise level 13 dB(A)»
One sensitivity and one noise figure cover four switchable patterns (cardioid, hypercardioid, omni, figure-8), with no pattern named. The same three numbers - 25 mV/Pa (-32 dBV), 13 dB equivalent noise, 81 dB signal-to-noise - are also printed on sE's page for the sE8, a fixed-cardioid half-inch pencil with a different capsule, different body and different max SPL. On the sE8 page the noise row reads «13 dB» with no weighting; here it reads «13 dB(A)».
geprüft am 6.8.2026* Geschätzt über das Abschreibungsmodell (~78% Restwert). · geprüft am 6.8.2026