AudioChainsDB
Electro-Voice

ND76

microphone

$119

Used market: $95*

Manufacturer datasheet

Specifications

5 of 7 values have a recorded source
Connectors
XLR 3-Pin Male·
Has Built In ADC
no·
Transducer Type
Dynamic Moving Coil
Sensitivity dBV
-52.4
Output Impedance ohms
350
Phantom Power Required
no
Connection Architecture
XLR-Only

Expert Audio Engineering Commentary

Tonal Profile

Neodymium cardioid handheld with a large Mylar diaphragm, a four-point capsule suspension and a pneumatic pump at the capsule base for handling noise. The data sheet gives two frequency responses - 30 Hz - 17 kHz close, 70 Hz - 17 kHz far - which is the proximity effect written down honestly.

Gain Staging Advice

2.4 mV/Pa is -52.4 dBV/Pa: 2.1 dB above an SM58 and 3.6 dB above an SM57, which puts it among the easier handheld dynamics to drive. The 350 ohm output is on the high side, so give it an input of 2 kilohms or more if you want the top end the capsule actually produces.

What the datasheet actually says

Quoted verbatim from the manufacturer’s own page, with the date we checked it. We state what is printed, not what anyone intended by it.

One figure, several models
«Sensitivity, Open Circuit Voltage @ 1 kHz: 2.4 mV/Pascal ... Impedance: 350 ohms balanced (low-z)»

Electro-Voice prints the same open-circuit voltage of 2.4 mV/Pascal and the same 350 ohm balanced impedance on the engineering data sheets of three ND-series microphones with three different polar patterns: ND76 (cardioid), ND86 (supercardioid) and ND44 (tight cardioid). One number covering three capsules may be correct, but it cannot be used to tell the three apart.

checked 8/5/2026

* Estimated with the depreciation fallback (~80% retained value). · checked on 8/5/2026