AudioChainsDB
RODE

Broadcaster

microphone

$399

Used market: $310*

Manufacturer datasheet

Specifications

5 of 7 values have a recorded source
Connectors
XLR 3-Pin Male·
Has Built In ADC
no·
Transducer Type
Condenser True
Sensitivity dBV
-34
Output Impedance ohms
40
Phantom Power Required
yes
Connection Architecture
XLR-Only

Expert Audio Engineering Commentary

Tonal Profile

End-address 1 inch cardioid condenser built for voice: internal pop shield, a switchable 75 Hz high-pass and an on-air LED that lights whenever phantom power is present.

Gain Staging Advice

-34.0 dBV/Pa with a 40 ohm output impedance, the lowest here by a factor of four. That combination is the argument for a condenser in a broadcast chain: 25 dB more level than an SM7B into a preamp that barely has to work, and an output stiff enough that cable length stops being a variable. Power is P24 or P48 - it does not need a full 48 V, which matters on bus-powered interfaces whose phantom rail sags.

* Estimated with the depreciation fallback (~78% retained value). · checked on 8/5/2026